1. Preparation |
|
![]() |
• Make sure the device is turned off, and if possible, remove the battery before installation. |
![]() |
• Wash your hands and wet your fingertips before handling any TechSkin™ pieces. This will help prevent fingerprints from forming on the film. |
![]() |
• Clean the device with a lint-free cloth, removing any dirt, grime, or fingerprints. |
2.
Installation |
|
![]() |
• Spray a fine but even layer of solution on the adhesive side of the TechSkin™piece you wish to install. Keep in mind that you do not need very much solution during installation. A Fine but even layer is the key to a good, clean install. |
![]() |
• Apply the TechSkin™ piece to the device with the adhesive side facing down. Begin with the larger pieces first, as they will act as a guide for small pieces. If a particular corner or small piece is not adhering to the device, let it dry for a few minutes before trying again. |
![]() |
• Wrap a credit card or hard plastic card in the included microfiber cloth. and gently push the excess solution and bubbles away from the center toward the edges. |
3. Perfection |
|
![]() |
• Please allow a few hours for the film to set and at least 4-5 hours before powering on your device. |
![]() |
• You can use a hair dryer, on low-setting, to quicken the process and help the film set faster. |
![]() |
• Micro-bubbles, streaks, and imperfections will disappear within 2-3 days. |