Skinomi DryTech™ Instructions:

Step 1: Preparation

• Make sure the device is turned off, and if possible, remove the battery before installation.

• Wash your hands thoroughly to rid your hands of any marks your fingerprints may leave. • Make sure to keep your hands moist to further lessen the chance of leaving marks on the DryTech™ film.

• Using a lint-free cloth, clean the device, removing any dirt, grime, or fingerprints from its surface.

• Identify the DryTech™ pieces and where they fit by comparing the pieces with the actual device.

Step 2: Installation

• Carefully apply the DryTech™ pieces to the device with adhesive side facing down. Begin with the larger pieces first, as they will act as a guide for the smaller pieces

• Using the installation card provided, gently push away from the center to the edges of the film. Simultaneously pushing the card while applying the film to the device is the best way to prevent bubbles.

Step 3: Perfection

• Allow at least a few hours for the film to set. Microbubbles, streaks, and imperfections will begin to disappear within 2-3 days. Larger bubbles will require more time to clear, but should be gone after 1-2 weeks.

Helpful Tips:

Perform installation in a clean and dust-free environment for best results.

WARNING: As with any electronic device, exposing yours to excessive water or fluids may cause the device harm. Skinomi will not be responsible for any damage to the device caused by improper installation of Skinomi DryTech™.